Service manual

Maintenance Analysis Procedures
3-53
Maintenence Analysis Procedures
10
An E_Port segmented because two products had incompatible zoning
configurations. An identical zone name is recognized in the active
zone set for both products, but the zones contain different members.
a. Determine the desired zone name change for one of the affected
products. Zone names must conform to the following rules:
The name must be 64 characters or fewer in length.
The first character must be a letter (a through z), upper or
lower case.
Other characters must be alphanumeric (a through z
or 0 through 9), dollar sign ($), hyphen (-), caret (^), or
underscore (_).
b. At the EFCM Basic Edition interface or SAN management
application, inspect names in the active zone set to determine
the incompatible zone name, then modify the name as directed
by the customer:
EFCM Basic Edition - Refer to the
McDATA EFCM Basic
Edition User Manual
(620-000240) for instructions.
SAN management application - Refer to the
SANavigator
Software Release 4.2 User Manual
(621-000013) or
EFC
Manager Software Release 8.7 User Manual
(620-000170)
for instructions.
Was the maintenance action successful?
NO YES
The fabric, ISL, and product are operational. Exit MAP.
Contact the next level of support. Exit MAP.
11
An E_Port segmented because a build fabric protocol error was
detected.
a. Disconnect the fiber-optic jumper cable from the segmented
E_Port.
b. Reconnect the cable to the same port.
Was the maintenance action successful?
NO YES
The fabric, ISL, and product are operational. Exit MAP.