Service manual

Maintenance Analysis Procedures
3-41
Maintenence Analysis Procedures
modify the IP address access control list, product-level authentication
settings, port-level authentication settings, and challenge handshake
authentication protocol (CHAP) sequence to ensure device access to
the product.
• EFCM Basic Edition - Refer to the
McDATA EFCM Basic Edition
User Manual
(620-000240).
• Element Manager - Refer to the
McDATA Intrepid 6140 and
6064 Directors Element Manager User Manual
(620-000153).
Was the maintenance action successful?
NO YES
↓ The product port is operational. Exit MAP.
Contact the next level of support. Exit MAP.
14
A port is set to an inactive state.
a. At the
Event Log , examine the first two bytes of event data.
b. Byte 0 specifies the port reporting the problem. Byte 1 specifies
theinactivereason(Table 3 -12 ).
15
A port is inactive because Flexport Technology is disabled. Install the
Flexport Technology PFE key to enable N_Port capability (
Task 16:
Configure PFE Key (Optional)
on page 2-51 and Install PFE Keys
(Optional)
on page 2-25). Exit MAP.
16
A port is inactive because the:
• Port cannot operate at the product (backplane) speed.
Table 3-12 Inactive Port Reasons and Actions
Byte 1 Inactive Port Reason Action
02 Feature key not enabled. Go to step 15.
03 Switch speed conflict. Go to step 16.
04 Optics speed conflict. Go to step 16.
06 Port swap conflict. Go to step 17.