Service manual

Maintenance Analysis Procedures
3-39
Maintenence Analysis Procedures
• If the port is operational with no device attached, both LEDs
adjacent to the port extinguish and the port state is
No Light .
• If the port is operational with a device attached, the blue/green
LED illuminates, the amber LED extinguishes, and the port state
is
Online .
Was the maintenance action successful?
NO YES
↓ The product port is operational. Exit MAP.
Contact the next level of support. Exit MAP.
8
An ISL connection is not allowed because E_Port capability is
disabled. Install the full-fabric PFE key to enable E_port capability
(
Task 16: Configure PFE Key (Optional) on page 2-51 and Install PFE
Keys (Optional)
on page 2-25). Exit MAP.
9
The connection timed out because of an unresponsive device or an
ISL security violation (authorization failure reject). Check port status
and clean fiber-optic components.
a. Inform the customer the port will be blocked. Ensure the system
administrator quiesces Fibre Channel frame traffic and sets
attached devices offline.
b. Block the port (
Blocking and Unblocking Ports on page 4-27).
c. Clean fiber-optic connectors (
Cleaning Fiber-Optic Components
on page 4-40.
d. Unblock the port (
Blocking and Unblocking Ports on page 4-27).
e. Monitor port operation for approximately five minutes.
Was the maintenance action successful?
NO YES
↓ The product port is operational. Exit MAP.
10
Inspect and service host bus adapters (HBAs).
Was the maintenance action successful?
NO YES
↓ The product port is operational. Exit MAP.