Service manual

3-28
Intrepid® 6140 Director Installation and Service Manual
Maintenence Analysis Procedures
g. Configure Port Settings parameters:
—
Bits per second - 115200.
—
Data bits - 8.
—
Parity - None.
—
Stop bits - 1.
—
Flow control - Hardware or None.
Click
OK .The New Connection - HyperTerminal window
displays.
h. At the > prompt, type the user password (default is password)
and press Enter. The password is case sensitive. The
New
Connection - HyperTerminal
window displays with software and
hardware version information for the product, and a C>prompt
at the bottom of the window.
i. At the C>prompt, type the ipconfig command and press Enter.
The
New Connection - HyperTerminal window displays with
configuration information listed.
j. Record the product IP address.
k. Select
Exit from the File pull-down menu. A HyperTerminal
message box appears.
l. Click
Ye s . A second message box appears. Click No to exit and
close the application.
m. Power off the maintenance terminal and disconnect the modem
cable. Replace the protective cap over the maintenance port.
Continue.
22
Define the product IP address (determined in step 21)tothe
management server.
a. At the SAN management application, select
Setup from the
Discover menu. The Discover Setup dialog box displays.
b. Ensure the product to be reconfigured is moved from the
Selected Individual Addresses list to the Available Addresses
list. Select (highlight) the product and click Edit .The Address
Properties
dialog box displays with the IP Address page open.
c. Type the correct product IP address in the
IP Address field.