Service manual

2
2-74
Intrepid® 6140 Director Installation and Service Manual
Installation Tasks
• A zone set name cannot contain spaces.
• Valid characters are alphanumerics and the caret ( ^ ),
hyphen ( - ), underscore ( _ ), or dollar ( $ ) symbols.
• A zone set name can have a maximum of 64 characters.
If the installation is performed from the EFCM Basic Edition
interface, refer to the McDATA EFCM Basic Edition User Manual
(620-000240) for instructions. If the installation is performed fromthe
management server, refer to the SANavigator Software Release 4.2 User
Manual (621-000013) or EFC Manager Software Release 8.7 User Manual
(620-000170) for instructions.
Task 23: Connect Director to a Fabric Element (Optional)
To provide fabric-attached Fibre channel connectivity for devices
connected to the director, connect the director to an expansion port
(E_Port) of a fabric element (switch or director). Any switch can be
used to form this ISL. To connect the director to a fabric element and
create an ISL:
1. Ensure the fabric element is defined to the SAN management
application or accessible by the EFCM Basic Edition interface. If
the fabric element must be defined, refer to the appropriate
switch or director installation manual for instructions.
2. Ensure the preferred domain ID for the director is unique and
does not conflict with the ID of another switch or director
participating in the fabric.
— If the domain ID must be changed from the EFCM Basic
Edition, refer to Task 4: Configure Director at the EFCM Basic
Edition Interface (Optional) on page 2-11.
— If the domain ID must be changed from the management
server, refer to Task 19: Configure the Element Manager
Application on page 2-55.
3. Ensure R_A_TOV and E_D_TOV values for the director are
identical to the values for all switches or directors participating in
the fabric.
— If the values must be changed from the EFCM Basic Edition,
refer to Task 4: Configure Director at the EFCM Basic Edition
Interface (Optional) on page 2-11.