Service manual

2
Task 8: Configure Management Server Information
2-41
Installation Tasks
Where xxx.xxx.xxx.xxx is the default IP address of 10.1.1.1 or the
IP address configured while performing Task 7: Configure Server
Password and Network Addresses. The VNC Authentication screen
appears.
3. Type the default password and click OK. The Welcome to Windows
dialog box appears.
NOTE: The default TightVNC viewer password is password.
4. Click the Send Ctrl-Alt-Del button at the top of the window to
log on to the server desktop. The Log On to Windows dialog box
appears.
NOTE: Do not simultaneously press the Ctrl, Alt, and Delete keys. This
action logs the user on to the browser-capable PC, not the server.
5. Type the default Windows user name and password and click
OK. The server’s Windows desktop opens and the EFCM Log In
dialog box appears.
NOTE: The default Windows user name is Administrator and the
default password is password. Both are case-sensitive.
Configure
Management
Server Names
To configure the management server name and workgroup name use
the following steps:
1. Open the system properties dialog box from the Windows
desktop (Start>Settings>Control Panel>System). The System
Properties dialog box appears with the General tab open by default.
2. Click the Network Identification tab. The System Properties dialog
box appears with the Network Identification tab selected.
3. Click Properties. The Identification Changes dialog box appears
(Figure 2-17).