Service manual

2
2-34
McDATA Sphereon 4400 Fabric Switch Installation and Service Manual
Installation Tasks
7. Configure Port Settings parameters:
— Bits per second - 115200.
— Data bits - 8.
— Parity - None.
— Stop bits - 1.
— Flow control - Hardware or None.
Click OK. The New Connection - HyperTerminal window appears.
8. Type the user password (default is password) at the > prompt,
and press Enter. The password is case sensitive. The New
Connection - HyperTerminal window appears with software and
hardware version information for the product, and a C > prompt
at the bottom of the window.
9. Type the ipconfig command at the C > prompt, and press Enter.
The New Connection - HyperTerminal window appears with
configuration information listed:
— MAC Address.
— IP Address (default is 10.1.1.10).
— Subnet Mask (default is 255.0.0.0).
— Gateway Address (default is 0.0.0.0).
— Auto Negotiate.
— Speed.
— Duplex.
Only the IP Address, Subnet Mask, and Gateway Address fields are
configurable.
10. Change the IP address, subnet mask, and gateway address as
directed by the customer. To change the addresses, type the
following at the C > prompt and press Enter
.
ipconfig xxx.xxx.xxx.xxx yyy.yyy.yyy.yyy zzz.zzz.zzz.zzz
The IP address is xxx.xxx.xxx.xxx, the subnet mask is
yyy.yyy.yyy.yyy, and the gateway address is zzz.zzz.zzz.zzz,
where the octets xxx, yyy, and zzz are decimals from zero
through 255. If an address is to remain unchanged, type the
current address in the respective field.