Service manual

2
Task 5: Configure Product Network Information (Optional)
2-33
Installation Tasks
1. Use a Phillips screwdriver to remove the protective cap from the
9-pin maintenance port at the rear of the chassis. Connect one end
of the RS-232 modem cable to the port.
2. Connect the other cable end to a 9-pin serial communication port
(COM1 or COM2) at the rear of the maintenance terminal PC.
3. Power on the maintenance terminal. At the Windows desktop,
click Start at the left side of the task bar. The Windows Workstation
menu appears.
NOTE: The following steps describe changing network addresses using
HyperTerminal serial communication software.
4. Open the HyperTerminal window on your Windows Workstation
(Start>Programs>Accessories>Communications>HyperTerminal). The
Connection Description dialog box appears (Figure 2-15).
Figure 2-15 Connection Description Dialog Box
5. Type a descriptive product name in the Name field and click OK.
The Connect To dialog box appears.
6. Ensure that the Connect using field displays COM1 or COM2
(depending on the port connection to the product), and click OK.
The COMn Properties dialog box appears, where n is 1 or 2.