Service manual

2
2-32
McDATA Sphereon 4400 Fabric Switch Installation and Service Manual
Installation Tasks
Task 5: Configure Product Network Information (Optional)
Follow the procedures in this section to configure product network
information:
• MAC address - The media access control (MAC) address is
programmed into FLASH memory on the control processor (CTP)
card at manufacture. The MAC address is unique for each
product, and should not be changed.
• IP address - The default IP address is 10.1.1.10. If multiple
products are installed on the same LAN, each product (and the
management server) must have a unique IP address.
NOTE: If multiple products and the management server are delivered in
a Fabricenter equipment cabinet, all devices are configured with unique
IP addresses that do not require change. The addresses require change
only if multiple cabinets are LAN-connected.
• Subnet mask - The default subnet mask is 255.0.0.0. If the
product is installed on a complex public LAN with one or more
routers, the address may require change.
• Gateway address - The default gateway address is 0.0.0.0. If the
product is installed on a public LAN, the gateway address must
be changed to the address of the corporate intranet’s local router.
Ensure that the LAN installation with the customer.
• If one product is installed on a dedicated LAN, network
addresses do not require change. Go to Task 6: Unpack, Inspect, and
Install the Management Server.
• If multiple products are installed or a public LAN segment is
used, network addresses must be changed to conform to the
customer’s LAN addressing scheme.
Perform the following steps to change a product IP address, subnet
mask, or gateway address.
NOTE: An asynchronous RS-232 modem cable and maintenance terminal
(desktop or notebook PC) with a Windows-based operating system and
RS-232 serial communication software (such as ProComm Plus or
HyperTerminal) are required.