Service manual

2
Task 4: Configure Product at the EFCM Basic Edition Interface (Optional)
2-29
Installation Tasks
3. Click OK. New PFE key(s) activate, the message Feature
installation in process. Your browser connection will be
unavailable until unit restart is complete. appears, and the
product performs a non-disruptive (to Fibre Channel traffic)
firmware reset.
After the product reset, the message Feature installation
complete. Click here
to login. appears.
4. Click here
to login and start a new EFCM Basic Edition session.
The Enter Network Password dialog box appears.
Configure Security
This section describes the security features for the product that may
be optionally configured.
NOTE: The enhanced SANtegrity PFE key (SANtegrity authentication and
SANtegrity binding) must be installed (Installing PFE Keys (Optional)) to
configure these features.
Select Security from the configrue menu (Configure>Security) and
choose from one of the following options in the drop-down menu:
• Authentication settings - The Authentication Settings View
provides four pages to configure optional SANtegrity
authentication features, including:
— User settings - Configure password-protected administrator
and operator access to the EFCM Basic Edition and command
line interfaces.
— Software settings - Configure challenge handshake
authentication protocol (CHAP) controlled management
interface access (out-of-band and inband) to the product.
— Device settings - Configure a CHAP secret authentication
sequence for nodes (devices) attached to the product through
E_Ports or N_ports.
— Port settings - Override product-level authentication settings
and enable or disable device communication on a per-port
basis.
• IP Access control list - Use the IP Access Control List View to
configure a list of device IP addresses or a range of device IP
addresses authorized to communicate with the product.