Service manual

2
2-24
McDATA Sphereon 4400 Fabric Switch Installation and Service Manual
Installation Tasks
d. Type a community name, for each configured recipient (32
alphanumeric characters or less) in the Name field. The name is
incorporated in SNMP trap messages to ensure against
unauthorized viewing.
e. Check the box in the Write Auth column to enable write
authorization for the trap recipient (default is disabled). When
enabled, a configured user can change sysContact, sysName,
and sysLocation SNMP variables.
f. Type the IP address or DNS host name of the trap recipient
(SNMP management workstation) in the Trap Recipient field. It
is recommended that the IP address be used.
g. Type a decimal port number in the UDP Port Number field to
specify the UDP port number.
2. Click OK to save and activate changes.
Enable CLI
Follow the procedure in this section to toggle (enable or disable) the
state of the product’s command line interface. To change the CLI
state, Enable the check box Enable CLI from the Configure menu
Enable or Disable
the CLI for SSH
To configure SSH, Select Configure > SSH on the navigation panel.
The SSH configuration page (Figure 2-11) appears.
Figure 2-11 SSH Configuration