Service manual

2
Task 4: Configure Product at the EFCM Basic Edition Interface (Optional)
2-23
Installation Tasks
1. Select NPIV from the Configure menu (Configure>Ports>NPIV).
The NPIV View appears.
2. Click Enable to activate NPIV operation for the product.
3. Type a desired value(1 through 256) in the Login column.
4. Click OK to save and activate changes.
Configure SNMP
Follow the procedure in this section to configure names, write
authorizations, addresses, and user datagram protocol (UDP) port
numbers for SNMP trap message recipients.
To configure recipient workstations, use the following steps:
1. Select SNMP from the Configure menu (Configure>SNMP). The
SNMP View appears (Figure 2-10).
a. Click Enable to activate the installed SNMP agent.
b. Select the appropriate Fibre Alliance management information
base (FA MIB) from the FA MIB Version drop-down list. Valid
selections are FA MIB Version 3.0 or FA MIB Version 3.1.
Figure 2-10 SNMP View
c. Check the Enable Authentication Traps check box to enable
transmission of SNMP trap messages to recipients.