Service manual

2
Task 4: Configure Product at the EFCM Basic Edition Interface (Optional)
2-19
Installation Tasks
• McDATA Fabric 1.0 - Select this option if the product is
fabric-attached only to other McDATA directors or
switches operating in McDATA fabric mode.
• Open Fabric 1.0 - Select this option (default) for managing
heterogeneous fabrics and if the product is fabric-attached
to McDATA directors or switches and other open-fabric
compliant switches.
NOTE: With Open Fabric 1.0 enabled, the default zone set is
disabled.
e. Select from the ISL Cost Configuration drop-down list, to select
By Port Speed or Ignore Port Speed to calculate fabric shortest
path first (FSPF) cost.
3. Click OK to save and activate changes.
4. Set the product online. Refer to Setting Online State for
instructions.
Configure Network
Information
Follow the procedure in this section to configure the network
information.
Ensure the LAN installation with the network administrator:
• If one product is installed on a dedicated LAN, network
information (IP address, subnet mask, and gateway address) does
not require any change.
• Multiple products are installed or a public LAN segment is used,
network information must be changed to conform to the LAN
addressing scheme.
To change product network information, use the following steps:
1. Select Network from the Configure menu
(Configure>Switch>Network). The Network View appears
(Figure 2-8).