Service manual

2
Task 4: Configure Product at the EFCM Basic Edition Interface (Optional)
2-17
Installation Tasks
e. Enable (check) the Domain RSCN field, if you want the
attached devices to register and receive notification when
other devices change state.
f. Enable (check) the Suppress RSCN on Zone Set Activations if you
do not want the RSCNs to be transmitted when a zone set is
activated.
g. Enable (check) the Isolate on zone activations field if you want
only devices that require RSCN notification due to a zoning
configuration change to receive RSCNs. Do not enable this
option if Suppress on zone set activations is enabled because
RSCNs will not be sent to attached devices.
h. Enable (check) the Limited Fabric RSCN field if you do not
want the RSCNs to be transmitted after a switch initial
program load (IPL).
i. Enable (check) the Node port virtualization to assign multiple
Fibre Channel addresses to a single N_Port port.
3. Click OK to save and activate changes.
4. Set the product online. Refer to Setting Online State for
instructions.
Configure Fabric
Parameters
To configure fabric operating parameters, use the following steps.
1. Set the product offline. Refer to Setting Online State for
instructions.
2. Select Fabric Parameters from the Configure menu
(Configure>Switch>Fabric Parameters). The Fabric Parameters View
appears (Figure 2-7).