Service manual

2
2-12
McDATA Sphereon 4400 Fabric Switch Installation and Service Manual
Installation Tasks
— If the switch is to be managed through the EFCM Basic Edition
interface, go to Task 4: Configure Product at the EFCM Basic
Edition Interface (Optional).
— If the switch is to be managed through a management or
customer-supplied server, go to Task 5: Configure Product
Network Information (Optional).
Task 4: Configure Product at the EFCM Basic Edition Interface
(Optional)
Follow the procedures in this section to configure the product from
the EFCM Basic Edition interface. A browser-capable PC with
Internet or Ethernet LAN access is required. To open the interface,
use the following steps:
1. Connect the Ethernet patch cable (supplied with the product) to
the RJ-45 connector (labelled 10/100) at the front panel.
2. Connect the remaining end of the Ethernet cable to the Internet or
LAN segment as directed by the customer. If the hub installed in
Task 2: Unpack, Inspect, and Install the Ethernet Hub (Optional)
provides connectivity, connect the cable to any available hub
port.
3. Open the browser application (Netscape Navigator
or Internet
Explorer).
4. Enter the default Internet Protocol (IP) address of the switch
(10.1.1.10). The Enter Network Password dialog box appears.
5. Type the case-sensitive default user name (Administrator) and
password (password) and click OK. The First Time Login View
appears.
6. Type customer-specified values in the User Name, New Password,
and Confirm Password fields, then click Activate. The Topology View
appears with status information about each fabric element,
including the product to be configured.
7. Click Switch Details. The Hardware View appears (Figure 2-3).