Service manual

4
Repair Procedures - SAN Management Application
4-53
Repair Information
Figure 4-20 Reset Configuration Dialog Box
4. Click Reset to initiate the reset operation and close the dialog box.
5. The switch IP address resets to the default address of 10.1.1.10.
— If the configured IP address (prior to reset) was the same as
the default address, the switch-to-management server
Ethernet link is not affected and the procedure is complete.
— If the configured IP address (prior to reset) was not the same
as the default address, the switch-to-management server
Ethernet link drops and server communication is lost.
Continue to the next step.
6. To change the switch IP address and restart the management
server session, go to step 7. To restart a management server
session using the default IP address of 10.1.1.10:
a. Close the Element Manager application and return to the SAN
management application.
A grey square with a yellow exclamation mark appears adjacent
to the icon representing the reset switch, indicating switch is not
communicating with the management server.
b. Select Setup from the Discover menu(Discover>Setup). The
Discover Setup dialog box appears (Figure 4-21).