Service manual

4
Repair Procedures - SAN Management Application
4-51
Repair Information
d. The switch performs an IPL, during which an IPLing message
appears at the Send Firmware dialog box. In addition, the
switch-to-management server Ethernet link drops
momentarily.
5. A Send firmware complete message appears at the Send Firmware
dialog box.
6. Click Close to close the Firmware Library dialog box.
Managing
Configuration Data
The Element Manager application provides options to:
• Back up and restore the configuration file stored in NV-RAM on
the switch CTP card.
• Reset the configuration file to factory default values.
The switch must be set offline prior to restoring or resetting the
configuration file.
Back Up Configuration To back up the switch configuration file to the management server:
1. Select Backup & Restore Configuration from the Maintenance menu
(Maintenance>Backup&Restore Configuration). The Backup and
Restore Configuration dialog box appearsappears (Figure 4-19).
Figure 4-19 Backup and Restore Configuration Dialog Box
2. Click Backup. An Information dialog box appears, indicating the
backup was initiated.
3. Click OK to complete the backup and close the dialog box.
Restore Configuration To restore the switch configuration file from the management server:
Inform the customer the switch is to be set offline. Ensure the system
administrator quiesces Fibre Channel frame traffic through the
switch and sets attached FC-AL devices offline.