Service manual

4
4-46
McDATA Sphereon 4400 Fabric Switch Installation and Service Manual
Repair Information
2. Remove the backup CD from the management server’s compact
disk-rewritable (CD-RW) drive and insert a blank rewritable CD.
3. Select the compact disc drive (D:\) from the Look in drop-down
menu at the Save Data Collection dialog box. Type a descriptive
name for the collected maintenance data in the File name field,
then click Save.
4. The Data Collection dialog box appears with a progress bar that
shows percent completion of the data collection process. When
the process reaches 100%, the Cancel button changes to a Close
Button.
5. Click Close to close the dialog box.
6. Remove the CD with the newly-collected maintenance data from
the management server’s CD-RW drive. Return the CD with the
failed FRU to support personnel for failure analysis.
7. To ensure that the backup application operates normally, replace
the original backup CD in the management server’s CD-RW
drive.
Setting Online State
This section describes procedures to set the product online or offline.
Operational states are:
• Online - When the product is set online, an attached device can
log in if the port is not blocked. Attached devices in the same
zone can communicate with each other.
• Offline - When the product is set offline, all ports are set offline
and operation of attached Fibre Channel devices is disrupted. The
product transmits the OLS to attached devices, and the devices
cannot log in.
NOTE: Do not set the product offline unless directed to do so by a procedural
step or the next level of support.
To set the product online or offline use the following steps:
1. Select Set Online State from the Maintenance menu
(Maintenance>Set Online State). The Set Online State dialog box
appears (Figure 4-17).