Service manual

4
4-28
McDATA Sphereon 4400 Fabric Switch Installation and Service Manual
Repair Information
— If the configured IP address (prior to reset) was the same as
the default address, the browser-to-switch Internet connection
is not affected and the procedure is complete.
— If the configured IP address (prior to reset) was not the
same as the default address, the browser-to-switch Internet
connection drops and the EFCM Basic Edition session is lost.
Continue to the next step.
6. To change the switch IP address and restart the EFCM Basic
Edition interface, refer to Configure Network Information. To restart
the EFCM Basic Edition interface using the default IP address of
10.1.1.10:
a. Enter the default IP address of 10.1.1.10 at the browser, as the
Internet URL. The Enter Network Password dialog box appears.
b. Type the default user name and password.
NOTE: The default user name is Administrator and the default
password is password. The user name and password are
case-sensitive.
c. Click OK. The EFCM Basic Edition interface opens and the
procedure is complete.
Repair Procedures - SAN Management Application
The following procedures (performed at a rack-mount management
server running a SAN management application) are described. SAN
management applications include EFCM 8.7 (or later).
• Obtaining Fabric Log Information on page 4-29
• Obtaining Switch Log Information on page 4-30
• Performing Port Diagnostics on page 4-35
• Collecting Maintenance Data on page 4-45
• Setting Online State on page 4-46
• Blocking or Unblocking a Port on page 4-47
• Upgrading Firmware on page 4-48
• Managing Configuration Data on page 4-51
• Installing or Upgrading Software on page 4-55