Service manual

3
MAP 0000: Start MAP
3-9
Maintenence Analysis Procedures
— EFCM Basic Edition - Select Link Incident from the Logs
menu at any view. The Link Incident Log displays.
— Element Manager - Select Link Incident Log from the Logs
menu at any view. The Link Incident Log displays.
b. If a link incident occurred, the port number is listed with one of
the following messages.
— Link interface incident - implicit incident.
— Link interface incident - bit-error threshold exceeded.
— Link failure - loss of signal or loss of synchronization.
— Link failure - not-operational primitive sequence (NOS)
received.
— Link failure - primitive sequence timeout.
— Link failure - invalid primitive sequence received for the
current link state.
Did a listed message appear?
NO YES
↓ A Fibre Channel link incident is indicated. Go to MAP 0500:
Port Failure or Link Incident Analysis. Exit MAP.
Perform a data collection and contact the next level of support. Refer
to Collecting Maintenance Data (EFCM Basic Edition) or Collecting
Maintenance Data (Element Manager). Exit MAP.
9
If an incident occurs on the Fibre Channel link between the product
and attached OSI server, a link incident record is generated and sent
to the server console using the reporting procedure defined in
T11/99-017v0.
Was a link incident record generated and sent to the OSI server?
NO YES
↓ A Fibre Channel link incident is indicated. Go to MAP 0500:
Port Failure or Link Incident Analysis. Exit MAP.
Perform a data collection and contact the next level of support. Refer
to Collecting Maintenance Data (EFCM Basic Edition) or Collecting
Maintenance Data (Element Manager). Exit MAP.