Service manual

2
2-72
McDATA Sphereon 4400 Fabric Switch Installation and Service Manual
Installation Tasks
13. Select Enable E-Mail Notification from the Maintenance menu at any
view. A check mark appears to indicate e-mail notification for the
product is enabled.
NOTE: The enable function must be activated for each product through
the Element Manager application.
Configure and
Enable Ethernet
Events
Perform this procedure to configure and enable Ethernet events. An
Ethernet event is recorded (after a user-specified time interval) when
the switch-to-management server communication link drops.
To configure and enable Ethernet events, use the following steps:
1. Select Ethernet Event from the Monitor menu in the EFCM main
window. The Configure Ethernet Events dialog box appears..
2. Enable the Enable Ethernet Events check box. .
3. Type a value between 10 - 120 minutes in the Ethernet Timeout
field.
4. Click OK to close the dialog box.
Configure, Enable,
and Test Call-Home
Event Notification
Telephone numbers and other information for the call-home feature
are configured through the Windows dial-up networking
application. Refer to Task 11: Configure the Call-Home Feature (Optional)
for configuration instructions.
To configure, enable, and test call-home event notification, use the
following steps:
NOTE: The call-home feature may not be available if the EFCM Lite
application is installed on a customer-supplied platform.
1. Select Call Home from the Monitor menu (Monitor>Event
Notification>Call Home) in the EFCM main window. The Call Home
Event Notification Setup dialog box appears..
2. Enable the Enable Call Home Event Notification check box.
NOTE: The enable function must be activated for each product through
the Element Manager application.
3. Click Send Test. A call-home test message is sent.