Twist ’N Edge GB INSTRUCTION MANUAL IMPORTANT INFORMATION: Please read these instructions carefully and make sure you understand them before using this unit. Retain these instructions for future reference.
IDENTIFICATION (WHAT IS WHAT?) Shaft Assist handle Edge Guide Primer bulb Shield Trimmer Head Muffler Throttle trigger Choke lever Manual Fuel tank ON/STOP Switch Wrench Starter handle IDENTIFICATION OF SYMBOLS A. B. C. D. E. F. G. H. I. J. WARNING! This trimmer can be dangerous! Careless or improper use can cause serious or even fatal injury. Read and understand the instruction manual before using the trimmer. Never use blades or flailing devices with this tool.
SAFETY RULES WARNING: When using gardening appliances, basic safety precautions should always be followed to reduce the risk of fire and serious injury. Read and follow all instructions. This power unit can be dangerous! Operator is responsible for following instructions and warnings on unit and in manual. Read entire instruction manual before using unit! Be thoroughly familiar with the controls and the proper use of the unit.
CUTTING SAFETY WARNING: Inspect the area before each use. Remove objects (rocks, broken glass, nails, wire, etc.) which can be thrown by or become entangled in line. Hard objects can damage the trimmer head and be thrown causing serious injury. S Use only for trimming, scalping, mowing sweeping, and edging. Do not use for pruning or hedge trimming. S Keep firm footing and balance. Do not overreach. S Keep all parts of your body away from muffler and spinning line. Keep engine below waist level.
OPERATION WARNING: Be sure to read the fuel information in the safety rules before you begin. If you do not understand the safety rules, do not attempt to fuel your unit. Contact an authorized service dealer. 4. Move choke lever to FULL CHOKE position. 5. Squeeze and hold trigger through all remaining steps. Primer Bulb FUELING ENGINE WARNING: Remove fuel cap slowly when refueling. This engine is certified to operate on unleaded gasoline.
3. Squeeze and hold the throttle trigger. Keep throttle trigger fully squeezed until the engine runs smoothly. 4. Pull starter rope sharply until engine runs, but no more than 5 pulls. 5. Allow engine to run 15 seconds, then move the choke lever to the RUN position. NOTE: If engine has not started, pull starter rope 5 more pulls. If engine still does not run, it is probably flooded..
TRIMMING -- Hold the bottom of the trimmer head about 8 cm above the ground and at an angle. Allow only the tip of the line to make contact. Do not force trimmer line into work area. Mowing Trimming SWEEPING -- The fanning action of the rotating line can be used for a quick and easy clean up. Keep the line parallel to and above the surfaces being swept and move the tool from side to side. 3 inches (8 cm) above ground Sweeping SCALPING -- The scalping technique removes unwanted vegetation.
NOTE: Do not clean filter in gasoline or other flammable solvent to avoid creating a fire hazard or producing harmful evaporative emissions. 3. Wash the filter in soap and water. 4. Allow filter to dry. 5. Replace parts. Button Air Filter REPLACE SPARK PLUG Replace the spark plug each year to ensure the engine starts easier and runs better. Set spark plug gap at 0,6 mm. Ignition timing is fixed and nonadjustable. 1. Twist, then pull off spark plug boot. 2. Remove spark plug from cylinder and discard. 3.
CARBURETOR ADJUSTMENT WARNING: Keep others away when making idle speed adjustments. The trimmer head will be spinning during this procedure. Wear your protective equipment and observe all safety precautions. The carburetor has been carefully set at the factory. Adjustments may be necessary if you notice any of the following conditions: S Engine will not idle when the throttle is released.
TROUBLESHOOTING TABLE WARNING: Always stop unit and disconnect spark plug before performing all of the recommended remedies below except remedies that require operation of the unit. TROUBLE CAUSE REMEDY Engine will not start. 1. ON/STOP switch in STOP position. 2. Engine flooded. 1. Move ON/STOP switch to STOP position. 2. See “Starting a Flooded Engine” in Operation Section. 3. Fill tank with correct fuel mixture. 4. Install new spark plug. 5. Check for dirty fuel filter; replace.
DECLARATION OF CONFORMITY EC Declaration of Conformity (Only applies to Europe) We, Husqvarna Outdoor Products Italia, S.p.A., Valmadrera, Italy.
TECHNICAL DATA SHEET MODEL: Twist ’N Edge ENGINE Displacement, cm3 Maximum engine power, measured in accordance with ISO 8893, kW ENGINE ROTATIONAL SPEEDS At maximum engine power, rpm Maximum rotational frequency of the spindle, rpm Engine speed at recommended maximum spindle rotational frequency, rpm Recommended speed idling, rpm FUEL AND LUBRICATION SYSTEM Fuel tank volume capacity, cm3 Fuel consumption at maximum engine power, measured in accordance with ISO 8893, g/h Specified fuel consumption at max.
Husqvarna Outdoor Products Italia S.p.A. Via Como 72 Valmadrera, Lecco ITALY I--23868 Visit our website at www.mcculloch-- europe.
