User Guide

6
|
ENGLISH
STEAM MOPPING ACCESSORIES
WARNING: Do not try to connect accessories while unit is emitting steam.
EXTENSION WANDS
1. Select one of the Extension Wands. Insert end (A) of Wand into Main Nozzle (B). Align hole in
Wand with grey lock/release button on Nozzle.
2. Press down on grey lock/release button. While continuing to hold button down, slide
Extension Wand onto Main Nozzle until button snaps through hole on Wand.
3. Slide remaining Extension Wand (C) onto end of assembled Wand (D), this time lining up
rectangular hole of remaining Wand with grey lock/release button of rst Wand. Press and
hold button, and rmly push second Wand onto end of rst Wand until button snaps through
hole. Both Extension Wands should now be connected to the Main Nozzle.
MOP HEAD
1. Align Mop Head with open end of Extension Wand, so that rectangular hole in Mop Head
aligns with grey lock/release button on Wand.
2. Press down on grey lock/release button. While continuing to hold button down, slide Mop
Head onto Extension Wand (See gure 1-A). Press on rmly until button snaps through hole
(See gure 1-B).
NOTE: Do not use excessive force when mopping or using Extension Wands as this
may cause the Wands to break.
B
Assembling Your Multi-Use
Steam Canister
FIGURE 1
B
A
CA
D