Installation Guide

6 7 General InstructionsDummy Door Knob Installation
1. Placement
Decide where you would like to install the door
handle. Standard measurements below:
A. Door handle should be a minimum of 34”
o the floor and a maximum of 48” above the
floor. Standard practice is to install the handle
about 36” o the floor.
B. Standard back-set away from the door is
2⁄” or 2⁄”.
2. Install Dummy
Make sure the handle is level and use two
screws (Part C) and a drill to secure the
handle to the door. Repeat on second door if
relevant.
Dummy
Contents
Backset
2⅜” or 2¾”
Part A Part B
Part A Part B
Part C
Left Hand Right HandOUTSIDE
INSIDE
Left Hand Reverse Right Hand ReverseOUTSIDE
INSIDE
Lever Handing
Hinged Door Handing
Left Hand Lever Right Hand Lever
To determine the handing of your door, stand outside the door and face the door:
If the hinges are on the left hand side of the door frame, you need a left-handed
door set. If the hinges are on the right hand side of the door frame, you need a
right-handed door set. See diagram below for visual.
See below a diagram of a left hand lever versus a right hand lever.
Note
A. Door and door frame must be dry from any paint prior to installation.
B. Instruction photos show right hand installation. Instructions remain the same
for left handed doors, simply apply the same process in the reverse.