Installation Guide

2 3 Privacy Lock InstallationPrivacy Lock Installation
Part A
3. Install
Spindle
Insert spindle (part D) through door
hole and through latch. Refer to box
content to see which side to insert
first. Spindle should sit evenly on both
sides of the door.
4. Install
Exterior Trim
Insert exterior trim (part G) over
spindle on the exterior side of the door.
5. Install
Interior Trim
Insert interior trim (part F) over spindle
on the interior part of the door. Use
two large size screws (part H) to secure.
Insert privacy pin (part I) into the small
hole in the trim.
6. Door Jam Prep
Door face
1
⅜
”
D ep
1
”
⅛
e
”
1 ¼ ”
From
2
”
1
/
4
Measure to confirm the dimensions:
A. Diameter of the hole is 1”
B. Width of door jam is 1⁄”
C. Length of door jam is 2⁄”
D. The door should be chiseled to ⁄” deep
Place door strike (part C) over door jam and
use two small size screws (part J) to install.
2⅛” Diameter Hole
1” Diameter
2¼”
1”
Deep
Backset
2⅜” or 2¾”
⅛
”
1. Dimensions
Measure to confirm the following dimensions:
A. Diameter of the hole in the door is 2⁄”
B. Back-set of the hole is either 2⁄” or 2⁄”
C. Diameter of hole at edge of the door is 1”
D. Thickness of the door is 1⁄” or 1⁄”
E. The door edge is chiseled and is ⁄” deep
2. Install Latch
Insert latch (part E) into the hole at the edge
of the door. Place cover of your choice over
latch (part A or B) and use two small size
screws (part J) to secure.
Privacy Contents
Part B Part C
Part D
Part E
Part F Part G
Part F Part G
Part H Part I
Part J
Interior
Interior
Exterior
Exterior