McBowery Installation Manual
Privacy Contents 1. Dimensions Measure to confirm the following dimensions: Part A Part B A. Diameter of the hole in the door is 21/8” B. Back-set of the hole is either 23/8” or 23/4” C. Diameter of hole at edge of the door is 1” D. Thickness of the door is 13/8” or 13/4” E. The door edge is chiseled and is 1/8” deep Part C 3. Install Spindle 5. Install Interior Trim Insert spindle (part D) through door hole and through latch. Refer to box content to see which side to insert first.
Passage Contents 1. Dimensions Measure to confirm the following dimensions: Part A Part B A. Diameter of the hole in the door is 21/8” B. Back-set of the hole is either 23/8” or 23/4” C. Diameter of hole at edge of the door is 1” D. Thickness of the door is 13/8” or 13/4” E. The door edge is chiseled and is 1/8” deep Part C 3. Install Spindle 5. Install Interior Trim Insert spindle (part D) through door hole and through latch. Refer to box content to see which side to insert first.
Dummy Contents 1. Placement Note Decide where you would like to install the door handle. Standard measurements below: A. Door and door frame must be dry from any paint prior to installation. B. Instruction photos show right hand installation. Instructions remain the same for left handed doors, simply apply the same process in the reverse. A. Door handle should be a minimum of 34” off the floor and a maximum of 48” above the floor. Standard practice is to install the handle about 36” off the floor. B.
info@mcbowery.
