Installation guide

8
Set your password
1 Launch your Web browser. The UTM Firewall Management
Console window appears.
NOTE: If the UTM Firewall Management Console window does not
appear, navigate to 192.168.0.1. If you are unable to browse to
the UTM Firewall device at 192.168.0.1, or if the initial username
and password are not accepted:
a Press the erase button on the UTM Firewall device's rear panel
twice within 3 seconds, 1 second apart. This resets the UTM
Firewall device to its factory default settings.
b Wait 20–30 seconds, and then try browsing to 192.168.0.1
again.
2 A logon prompt appears. Enter the initial user name and
password:
•User name – root
• Password – default
3 Click OK. The Set Administrative Password window appears
(Figure 3).
Figure 3 Set Administrative Password window
.
uf_SG720_qig_700-2240A00_en-us.fm Page 8 Monday, October 12, 2009 11:56 AM