Installation guide

5
Unpack the UTM Firewall device
In addition to this document, check that you have the following
items included with your UTM Firewall device:
•Power cable
• UTM Firewall CD
•Network cable
The front panel of the UTM Firewall device has 2 10/100/1000 ports
(A and B), 3 10/100 ports (C, D, and E), a serial port, status LEDs,
and an Erase button (Appendix 1).
Figure 1 SG720 front panel
The status LEDs on the front panel provide information on the
operating status of the UTM Firewall device.
• The heart beat LED flashes when the UTM Firewall device is
running.
• Each of the network ports has two LEDs indicating link status and
activity.
• The four status LEDs flash when the device is in the factory
default state.
NOTE: If these LEDs do not behave in this manner before your UTM
Firewall device is attached to the network, perform a factory reset.
1 Press the erase button on rear panel twice within three seconds, 1
second apart to restore factory default settings.
2 If the LEDs are still not flashing after 30 seconds, contact customer
support.
SG720
Secure Network Gateway
Erase
Online
H/B H/A
PWRFailover
A
B
C
DE
10/100/1 000
10/100
Serial
uf_SG720_qig_700-2240A00_en-us.fm Page 5 Monday, October 12, 2009 11:56 AM