Installation guide

Select an option for your LAN configuration:

• [Recommended] To manually configure your LAN and

enable the built-in DHCP server option which

automatically configures the network settings of

computers and other hosts on your LAN, select Use a

Fixed IP.

• To use the initial network settings (page 6) as a basis for

your LAN settings and not use the built-in DHCP server,

select Skip.

• [Not recommended] If you have an existing DHCP server

and want to rely on the DHCP server to automatically

configure the UTM Firewall device LAN connection setting,

select Use an IP address obtained from a server on

the LAN (DHCP).

NOTE: Changes to the UTM Firewall device LAN configuration do not

take effect until you complete the Quick Setup Wizard.

4 Click Next. Continue based on the option you selected in Step 3.

• Use a Fixed IP – Go to step Step 5 on page 11.

• Skip – Go to step Step 6 on page 13.

• Use an IP address obtained from a server on the

LAN (DHCP) – Go to step Step 6 on page 13.

5 [Conditional] If you selected the Use a Fixed IP option,

manually configure your LAN settings:

a In the LAN Configuration window (Figure 5), enter an IP

address and Subnet Mask for the UTM Firewall device LAN

connection. Take note of the IP address and subnet mask; you

will need them later on.

uf_SG720_qig_700-2240A00_en-us.fm Page 11 Monday, October 12, 2009 11:56 AM