Installation guide

12
Manually configure network settings
Before continuing, ensure that you have two IP addresses available
that are part of the subnet range of your LAN. You will need the
following information:
• LAN subnet mask
• DNS server address used by computers on your LAN
• Gateway address used by computers on your LAN
Contact your network administrator if you are unsure of these
settings.
1 Enter IP address details for the Web Management Console.
a From the Network Setup page, select the Connections tab.
b Enter the IP Address that will be used by the Web Management
Console in the IP Address field (Figure 5).
Figure 5 Connections tab
c
Enter your LAN’s subnet mask in the Subnet Mask field.
d Confirm that the DHCP assigned checkbox is deselected.
uf_SG640_qig_700-2239A00_en-us.fm Page 12 Monday, October 12, 2009 12:06 PM