uf_SG640_qig_700-2239A00_en-us.
uf_SG640_qig_700-2239A00_en-us.fm Page 2 Monday, October 12, 2009 12:06 PM COPYRIGHT Copyright © 2009 McAfee, Inc. All Rights Reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form or by any means without the written permission of McAfee, Inc., or its suppliers or affiliate companies.
uf_SG640_qig_700-2239A00_en-us.fm Page 3 Monday, October 12, 2009 12:06 PM Introduction This Quick Installation Guide walks you through the installation of your UTM Firewall device. This guide is intended for anyone who needs to set up an SG640 McAfee UTM Firewall device. You can find additional information at the following locations: • Help – Help is built into the UTM Firewall Management Console. Click the Help icon in the upper right corner. • Support – Visit mysupport.mcafee.
uf_SG640_qig_700-2239A00_en-us.fm Page 4 Monday, October 12, 2009 12:06 PM Installation overview Installing the UTM Firewall device into a well-planned network is quick and easy. However, network planning and design is outside the scope of this guide. Please take some time to plan your network prior to installing your UTM Firewall device.
uf_SG640_qig_700-2239A00_en-us.fm Page 5 Monday, October 12, 2009 12:06 PM Unpack the device In addition to this document and the UTM Firewall PCI card, check that the UTM Firewall CD is included with your appliance. The UTM Firewall PCI card has a single 10/100 network port, a Reset button, and four LEDs (light-emitting diodes); see Figure 1. Figure 1 UTM Firewall PCI card 3 1 2 4 The LEDs provide information about the operating status of your UTM Firewall device. The two LEDs indicate: 1. power 3.
uf_SG640_qig_700-2239A00_en-us.fm Page 6 Monday, October 12, 2009 12:06 PM Install the UTM Firewall device in a PCI slot To install the UTM Firewall device: 1 Turn off the power to the host computer. 2 Remove the cover of the computer. 3 Locate an unused PCI slot on the computer, and insert the UTM Firewall device into it. 4 Replace the computer cover. 5 Turn on the computer.
uf_SG640_qig_700-2239A00_en-us.fm Page 7 Monday, October 12, 2009 12:06 PM Connect the computer to the Web Management Console This process assumes that you are setting up your UTM Firewall device in bridged mode, sitting between your computer and the LAN, and transparently filtering network traffic.
uf_SG640_qig_700-2239A00_en-us.fm Page 8 Monday, October 12, 2009 12:06 PM Figure 2 Internet Protocol Properties window 5 Enter the following details: • IP address – 192.168.0.100 • Subnet mask – 255.255.255.0 6 8 Leave the Default gateway and DNS server addresses blank.
uf_SG640_qig_700-2239A00_en-us.fm Page 9 Monday, October 12, 2009 12:06 PM Set your password 1 Launch your web browser, and navigate to 192.168.0.1. 2 On the management console, select Network Setup from the Network Setup menu. A login window displays. 3 Enter the initial user name and password for the UTM Firewall device: • User name – root • Password – default NOTE: If you cannot connect to the management console at 192.168.0.
uf_SG640_qig_700-2239A00_en-us.fm Page 10 Monday, October 12, 2009 12:06 PM Automatically configure network settings Before continuing, ensure that your DHCP server has two leases available. One lease will be used for the Web Management Console, and the other will be used for your computer. NOTE: It is strongly recommended that you reserve the IP address to be used by the Web Management Console using the UTM Firewall device MAC address.
uf_SG640_qig_700-2239A00_en-us.fm Page 11 Monday, October 12, 2009 12:06 PM 6 On the General tab, select Obtain an IP address automatically (Figure 4). Figure 4 Internet Protocol Properties window 7 Select Obtain DNS server address automatically. 8 Click OK. 9 Attach your UTM Firewall device Ethernet port to your LAN hub or switch. This completes the quick setup.
uf_SG640_qig_700-2239A00_en-us.fm Page 12 Monday, October 12, 2009 12:06 PM Manually configure network settings Before continuing, ensure that you have two IP addresses available that are part of the subnet range of your LAN. You will need the following information: • LAN subnet mask • DNS server address used by computers on your LAN • Gateway address used by computers on your LAN Contact your network administrator if you are unsure of these settings.
uf_SG640_qig_700-2239A00_en-us.fm Page 13 Monday, October 12, 2009 12:06 PM e [Optional] Enter one or more DNS server(s) and a gateway address to be used by the UTM Firewall device, not your computer, for access to the Internet. Typically, this is not necessary as only your computer needs to access the Internet. f 2 Click Update. Enter IP address details for your computer. a From the Start menu, select Control Panel, then double-click Network Connections.
uf_SG640_qig_700-2239A00_en-us.fm Page 14 Monday, October 12, 2009 12:06 PM Register your UTM Firewall device You must register your UTM Firewall in order to receive technical support. A current email address is required to register your product. For prompt product registration, go to my.securecomputing.com. Step-by-step procedures for registering your device and activating add-on features are provided in the McAfee UTM Firewall Administration Guide. This completes the setup of your UTM Firewall.
uf_SG640_qig_700-2239A00_en-us.fm Page 15 Monday, October 12, 2009 12:06 PM SOFTWARE LICENSE AGREEMENT NOTICE TO ALL USERS: PLEASE READ THIS CONTRACT CAREFULLY. BY CLICKING THE ACCEPT BUTTON OR INSTALLING THE SOFTWARE, YOU (EITHER AN INDIVIDUAL OR A SINGLE ENTITY) AGREE THAT THIS AGREEMENT IS ENFORCEABLE LIKE ANY WRITTEN CONTRACT SIGNED BY YOU.
uf_SG640_qig_700-2239A00_en-us.fm Page 16 Monday, October 12, 2009 12:06 PM 4 5 6 7 16 is included in the above described materials, then the Term shall be for one (1) year from the date of purchase unless earlier terminated as set forth herein. This Agreement will terminate automatically if you fail to comply with any of the limitations or other requirements described herein.
uf_SG640_qig_700-2239A00_en-us.fm Page 17 Monday, October 12, 2009 12:06 PM 8 9 or introduce the Beta Software, and that McAfee may not introduce a product similar to or compatible with the Beta Software. Accordingly, you acknowledge that any research or development that you perform regarding the Beta Software or any product associated with the Beta Software is done entirely at your own risk.
uf_SG640_qig_700-2239A00_en-us.fm Page 18 Monday, October 12, 2009 12:06 PM remainder of the original warranty period. Outside the United States, this remedy is not available to the extent McAfee is subject to restrictions under United States export control laws and regulations. c Warranty Disclaimer. Except for the limited warranty set forth herein, THE SOFTWARE IS PROVIDED "AS IS" AND MCAFEE MAKES NO WARRANTY AS TO ITS USE OR PERFORMANCE.
uf_SG640_qig_700-2239A00_en-us.fm Page 19 Monday, October 12, 2009 12:06 PM 12 Export Controls. You acknowledge that the Software is subject to the export control laws and regulations of the United State of America (“US”), and any amendments thereof.
uf_SG640_qig_700-2239A00_en-us.fm Page 20 Monday, October 12, 2009 12:06 PM 17 18 19 20 perform functions on its behalf, such as payment processing, order fulfillment, marketing programs and customer service. McAfee may share your information with such subcontractors in order to perform these and other functions, but such subcontractors may not use your personal information for other purposes, unless you agree.
