Installation guide

30
Chapter 4 Configuring NAT Addresses
Adding SMC Server Contact Addresses
The Management Server and the Log Server can have more than one contact address for each
Location. This allows you, for example, to define a contact address for each Internet link in a
Multi-Link configuration for remotely managed components.
 To define the Management Server and Log Server contact addresses
1. Select Configuration→Configuration→Security Engine. The Security Engine Configuration
view opens.
2. Expand the Network Elements branch and select Servers.
3. Right-click a server and select Properties. The Properties dialog for that server opens.
4. Select the Location of this server.
5. Enter the Default contact address. If the server has multiple alternative IP addresses,
separate the addresses with commas.
6. Click Exceptions and define Location-specific contact addresses if the Default Contact
Address(es) are not valid from all other Locations.
7. Click OK to close the server properties and define the contact addresses for other servers
in the same way.
Note – Elements grouped in the same Location element always use the primary IP address
(defined in the Properties dialog of the element) when contacting each other. All elements
not specifically put in a certain Location are treated as if they belonged to the same
Location.
What’s Next?
 Defining IPS Engines (page 33)
 Defining Layer 2 Firewalls (page 43)