Installation guide

110
Chapter 11 Installing the Engine on Other Platforms
Allocating Partitions
After partitioning the hard disk, the partitions are allocated for the engine.
 To allocate the partitions
1. Check that the partition table is correct. Type
yes to continue.
2. Using the partition numbers shown in the partition table, assign the partitions for the
engine, for example:
•For the engine root A partition, type
1.
•For the engine root B partition, type
2.
•For the swap partition, type
5.
•For the data partition, type
6.
•For the spool partition, type
7.
3. Check the partition allocation and type
yes to continue. The engine installation starts.
4. When installation is complete, remove the DVD from the machine and press Enter to
reboot.
What’s Next?
 Continue the configuration as described in Configuring the Engine Automatically with a
USB Stick (page 102) or Configuring the Engine in the Engine Configuration Wizard
(page 103).