Installation guide

105
Configuring the Engine in the Engine Configuration Wizard
Configuring the Network Interfaces
The Engine Configuration Wizard can automatically detect which network cards are in use. You
can also add interfaces manually if necessary. If the list is not populated automatically, you can
launch the autodetect as explained in the illustration below.
 To add the network interfaces
 Highlight Autodetect and press Enter.
Check that the detected drivers are correct and that all interfaces have been detected.
Defining the Network Interface Drivers Manually
 To define the network interface drivers manually
1. Highlight Add and press Enter.
2. Select a driver that is used for your network card(s) and press Enter.
What’s Next?
 If there are problems, add the network interfaces manually as explained in Defining the
Network Interface Drivers Manually.
 Otherwise, proceed to Mapping the Physical Interfaces to Interface IDs (page 106).
What’s Next?
 Repeat as necessary, then map the interfaces to Interface IDs as explained in Mapping
the Physical Interfaces to Interface IDs (page 106).