Installation guide

• If you select SQL authentication, provide the User name that ePolicy Orchestrator will
use. Then provide a password. If the installer cannot identify the port used for
communication to and from the server, you may be prompted to provide that information.
Otherwise, the SQL server TCP port field shows the port and is disabled.
When upgrading an installation using NT authentication, the Set Database Information
panel of the wizard appends the domain name to the User name field and
auto-populates the port field with 1433. For the installation to succeed, you must progress
past this page. Remove the domain from the user name field and click Next. You will
receive a port error. Dismiss this error and manually retype the port number 1433 and
click Next.
• For security reasons, ePolicy Orchestrator does not accept accounts with blank passwords.
NOTE: If you are installing on a system with a local SQL 2005 database server, you must
manually enter the TCP port number on the Set Database Information page of the
installation wizard.
11 Click Next to display the HTTP Configuration dialog box. The values that were set during
the original installation cannot be changed here.
PortFunction
Configurable. McAfee recommends using a port other
than 80.
Agent-to-Server communication port
Configurable.Agent Wake-Up communication port
Configurable port used to send SuperAgent wake up
calls.
Agent Broadcast communication port
Configurable.Event Parser-to-Server communication port
Configurable.Console-to-Application Server communication
port
Configurable port used by the Rogue System Detection
sensor to report host-detected messages to the Rogue
System Detection server using SSL.
Sensor-to-Server communication port
Port 8801.Security Threats communication port
Non-configurable port Used by McAfee Avert to
provide information on security threats and the
required DAT and engine versions to protect against
them
Port 1433.SQL server TCP port
Non-configurable.
12 Click Next. In the Default Notification Email Address dialog box, type the email address
for the recipient of messages from ePolicy Orchestrator Notifications, or keep the default
address. Changing the address is not required at this time. For more information, see the
Notifications chapter in the ePolicy Orchestrator 4.0 Product Guide.
a Provide the default destination for messages.
b Setting email server settings can be postponed until some time following installation by
selecting Setup email server settings later and leaving the default example address
untouched. However, the required information can be provided during installation.
Upgrading to ePolicy Orchestrator 4.0
Upgrading the server
19McAfee ePolicy Orchestrator 4.0 Installation Guide