User`s guide

PCIe-DIO96H User's Guide Functional Details
14
Replacing a fuse
The PCIe-DIO96H has two individual 1 amp slow blow fuses. One fuse is connected to the +5V User Output at
pin 49, and is labeled F1 on the board. The second fuse is connected to the +5V User Output at pin 99, and is
labeled F2 on the board. A spare fuse is installed on the board at location F3. All fuses are secured to the board
with clips for convenient replacement.
A fuse will blow during operation if amperage exceeds 1 amp. If you need to replace a fuse, perform the
following procedure.
1. Pry the center of the fuse from the fuse holder clip.
2. Insert the replacement fuse into the fuse holder clip.
Fuse specifications
Refer to the information below to purchase additional fuses, (or an equivalent), if required:
 Manufacturer: LittelFuse®
 Series: 452 Slo-Blo®
 Part number: 0452001. (Include the period as part of the item number.)
 1 amp, 125 volts, 0.225 Ω
 http://www.littelfuse.com/part/0452001..html