User`s guide

2. Trigger In Port

The Trigger In port is optionally used to synchronize I

C Bus data

collection with an external event. This port is located on the front of

the pod, and uses a BNC type connector. Input lines are provided

for signal and ground.

When Trigger In is enabled with the software Trace Control dialog,

data capture begins on the first I

C Bus Start condition after a high

to low transition on the Trigger In signal line.

Connect the pod to an external trigger circuit using the BNC to clip

lead cable provided.

Connecting to External Test Equipment (Optional)

The I

C Bus Monitor Plus pod includes two ports for connecting the

pod to external test equipment. These ports include:

1. Trigger Out Port