User`s guide

17
Download the Demonstration/Viewer Edition of the software from
the MCC web site (www.mcc-us.com/BMPlusDemo.htm). Follow
the instructions on screen.
Connecting Your PC to the Pod
The I
2
C Bus Monitor Plus pod contains the electronic circuitry
required to capture and record bus events, and communicate these
events with the interface card and software installed in your PC.
This section describes how to connect your PC to the I
2
C Bus
Monitor Plus pod.
1. Connect the previously installed interface card to the DB-37
connector at the rear of the I
2
C Bus Monitor Plus pod using the
interfacing cable provided.
2. Connect the included regulated 5VDC power supply cable to
the power connector on the rear of the pod.
3. Plug the power supply into a 120/240VAC 50/60Hz outlet.
4. Turn the pod power on. The red power light on the front of the
pod should illuminate.
5. To test the pod connection to your PC, run the I
2
C Bus
Monitor Plus Software described below and select