User`s guide

board and InstaCal driver software to access the external pod.

1. Installing the PCIe Card Driver Software

Insert the InstaCal CD you received with the I

C Bus Monitor

Plus into your DVD/CD-ROM drive. If the driver installer does

not start automatically, double-click on the installer

(icalsetup.exe) on the CD to begin the installation. Install the

InstaCal software by following the instructions on screen.

NOTE: Once the InstaCal driver software is installed, you must

restart your computer to complete the installation.

2. Installing the PCIe Card and Driver

This board is completely plug and play capable. To install the

interface board:

1. Following instructions provided with your computer, turn

your computer off, unplug the power, open the case, and

insert the PCIe-DIO24 board into an available PCI-e slot.

2. Close your computer case, plug in power, and turn it on.

3. Windows will automatically detect the board as it starts up

and will install the driver software.

3. Configuring the PCIe Card

Configure your interface board by running the InstaCal program

via the Start|Programs|Measurement Computing|InstaCal menu.

InstaCal will automatically detect the new board. Follow the

instructions on screen to complete the board configuration and

testing.