User`s manual

INT[1:0]
General Interrupt Source selection bits.
AD FIFO Not Empty11
AD FIFO Half Full01
End of Channel Scan10
External 00
SourceINT0 INT1
INTE
Enables interrupt source selected via the INT[1:0] bits.
1 = Selected interrupt Enabled.
0 = Selected interrupt Disabled
DAHFIE
Enables DAC FIFO Half-Full signal as an interrupt source. Used for high speed DAC
operations.
1= Enable DAC FIFO Half-Full interrupt.
0 = Disable DAC FIFO Half-Full interrupt
EOAIE
Enables End-of-Acquisition interrupt. Used during FIFO'd ADC operations to indicate
that the desired sample size has been gathered.
1 = Enable EOA interrupt.
0 = Disable EOA interrupt
DAHFCL
A write-clear to reset DAC FIFO Half-Full interrupt status.
1 = Clear DAC FIFO Half-Full interrupt.
0 = No effect.
EOACL
A write-clear to reset EOA interrupt status.
1 = Clear EOA interrupt.
0 = No effect.
INTCL
A write-clear to reset
INT[1:0]
selected interrupt status.
1 = Clear
INT[1:0]
interrupt
0 = No effect.
DAEMIE
Enables DAC FIFO Empty signal as an interrupt source.
1 = Enables DAC FIFO Empty interrupt.
0 = Disables DAC FIFO Empty interrupt.
ADFLCL
A write-clear to reset latched ADC FIFO Full status.
1
=
Clear ADC FIFO Full latch.
0 = No Effect.
DAEMCL
A write-clear to reset DAEM interrupt status.
1= Clear DAEM interrupt.
0 = No effect.
NOTE: It is not necessary to reset any write-clear bits after they are set.
BARD1 + 0 (Cont’d.)
10