User Manual
30
Symbol Option Function
d001 - d512 001-512 Setting the DMX starting address
P--1 - P--7 Setting the DMX operating mode
corl Operation with xed colour settings
r000 - r225 Setting the brightness red
G000 - G225 Setting the brightness green
b000 - b225 Setting the brightness blue
Pr01 - Pr26 01 - 26 Setting the effect programme
SP00 - SP20 Setting the effect speed
FS00 - FS20 Setting the strobe speed
Fd00 - Fd20 Setting the fade time
Au-1 - Au-3 1 - 3 Setting the automatic programme
n000 - n100 Setting the loops (programme runs)
SP00 - SP20 Setting the effect speed
FS00 - FS20 Setting the strobe speed
Fd00 - Fd20 Setting the fade time
Su00 - Su20 00 - 20 Setting the sound-to-light programme
SLAE Slave mode
Not every parameter can be selected in every programme (see overview).
b) Use with an External DMX Controller
Each DMX device in a DMX chain requires a so-called DMX starting address to be clearly identied by the controller.
This DMX starting address species the rst DMX channel to which the effect light responds. The remaining control
channels come after this rst DMX channel (DMX starting address).
The effect light requires up to 48 DMX channels depending on DMX operating mode.
Setting the DMX starting address
• Push the button MODE (6), until dxxx is displayed (xxx denes the DMX start address).
• Select the desired starting address 001-512 with the UP (8) and DOWN (9) buttons.
Setting the DMX operating mode
• Push the button SETUP (7), until Pxxx is displayed (xxx denes the DMX start address).
• Select the desired DMX operating mode P--1 to P--7 with the UP (8) and DOWN (9) buttons.