User manual

27
10. Operation
c) Master-Slave Mode
• Push the button FUNC until SLNd is displayed and push the button ENTER.
• Select the NASt with the arrow buttons to dene the effect light as master device (control via the integrated control
-
ler).
• Select the menu SLAv with the arrow buttons to dene the light effect as a slave device (control via the controller of
the connected master device).
• Conrm your selection again with ENTER.
If the device is to be operated as a single device (stand alone), it must be dened as a master device.
Only one device in a master-slave-chain must be dened as master device. All other devices must be
dened as slave devices.
In inverted slave mode, the device behaves opposite to the master device.
d) Automatic Mode
• Push the button FUNC until ShNd is displayed and push the button ENTER.
• Select the desired automatic effect SH 0 to SH 8 with the arrows.
•
Conrm your selection again with ENTER.
e) Sound-to-Light Mode
• Push the button FUNC until SoUn is displayed and push the button ENTER.
• Select on with the arrows to activate sound-to-light mode.
•
Conrm your selection again with ENTER.
• The effect light is controlled via an installed microphone in time with the music.
• Set
the music control sensitivity with the SOUND SENSITIVITY controller at the device.