User Manual LEDKANDYBARGB
Unpacking: Thank you for purchasing the LEDKANDYBARGB. Every LEDKANDYBARGB has been thoroughly tested and has been shipped in perfect operating condition. Carefully check the ship ping carton for damage that may have occurred during shipping. If the carton appears to be damaged, carefully inspect your fixture for any damage and be sure all equipment necessary to operate the unit has arrived intact.
channel mode CH CH CH CH CH CH CH CH 1- 3 1- 3 1- 3 1- 3 1- 3 1- 3 1- 3 1- 3 5 channel mode CH CH CH CH CH CH CH CH 3- 5 3- 5 3- 5 3- 5 3- 5 3- 5 3- 5 3- 5 8 channel mode CH CH CH CH CH CH CH CH 3- 5 3- 5 3- 5 3- 5 6- 8 6- 8 CH CH CH CH 3- 5 3- 5 24 channel mode CH CH CH CH CH 1- 3 4- 6 7- 9 10 -12 13- 15 26 channel mode CH CH CH 14 channel mode 3- 5 6- 8 6- 8 9- 11 6- 8 CH 12- 14 6- 8 6- 8 CH CH 9- 11 9- 11 CH 15- 17 CH
2. This will allow you to create your own programs. 3. Follow the instruction on page 16 to set the DMX address. DMX channel and function DMX valous and function Note: ote:when the function is strobing, the LED will be dimmered by channel 3-26 for channel mode.
Features of LEDKANDYBARGB • • • • • • • • • RGB Color Mixing Color Strobe Effect Color Mix Effect LED Chases (Adjustable Speeds) Electronic Dimming 0-100% Built in Microphone DMX-512 protocol Seven DMX Modes (See pages 8-9) 3 Operating Modes - Sound Active, Show Mode, or DMX Control • DMX-512 Protocol Compatible (Uses three , five ,eight , fourteen , twenty-four or twenty-six DMX Channels) • 3 Operating Modes - Master/Slave; dmx-control; Sound Active • Digital Display for Address and Function Setting On-
Addr - DMX Address Setting via control board and moter sstting 1. Tap the ESC button and UP button or DOWN button until “Addr” is displayed, press ENTER. 2. “Axxx” will now be displayed, “x” represents the displayed address. Press the UP or DOWN buttons to find your desired address. Auto - This menu will let you select your desired auto mode 1. Tap the ESC button and UP button or DOWN button until “Auto” is displayed, press ENTER. 2.
confirmed. 3. “AtF ” Make your own color by mixing and adjusting the red, blue and green manually. Select “AtF”, press ENTER,,”red ” ”Gree ”or”blue” will be displayed. red is first, press ENTER ,then you can adjust it between 1-255, press ESC ,you can select other color by UP or DOWN and then press ENTER to adjust it. soun - This menu will let you select your desired sound mode 1. Tap the MENU button until “Soun” is displayed, press ENTER. 2.
