Removal of Stock System: 1. Apply a penetrating lubricant liberally to all exhaust fasteners, hangers and rubber insulators. 2. Remove the exhaust system from the rubber insulators and remove all of the clamps from the catalytic converter back. Figure 1 3. Separate the slip joint behind the muffler and remove the tail pipe. Next, separate the slip joint located behind the catalytic converter and remove the muffler and extension pipe. Installation of MBRP Inc. “Smokers”: 1.
6. Cut a hole through the truck bed providing adequate clearance around the part of the T-Pipe that passes through the truck bed. MBRP Inc. recommends using a 5” diameter hole saw. It may be required to cut away part of a bed rail. Refer to Figure 4. Figure 4 7. Set the T-Pipe Assembly at the desired height from the floor of the bed (This will set the height of the Stacks).
Shown with 4” x 36” Stacks (B1410) Congratulations! You are ready to begin experiencing the improved power, sound and driving excitement of your MBRP Inc. S8102 © 02/13 “Smokers”: We are certain you will enjoy your purchase.
