Removal of Stock System: 1. Apply a penetrating lubricant liberally to all exhaust fasteners, hangers and rubber insulators. 2. Loosen the nut on the band clamp located behind the catalytic converter using a 15mm wrench or socket. See Figure 1. Figure 1 3. Remove the muffler and tail pipe from the OEM rubber hangers. To remove the system in one piece, on 03-04 models, the bottom shock bolt of the passenger side shock must be removed. This is not required on 05 or 06 models.
. Attach the factory catalytic converter to the Mid Pipe by placing the gasket supplied between the flanges and installing the two nuts that were removed previously. See Figure 6. Figure 6 4. Install the Extension Pipe over the catalytic converter. See Figure 7. Figure 7 5. Install the Muffler over the Extension Pipe. The Hanger Clamp is used at the connection between the Muffler and the Extension Pipe and installed into the OEM rubber hanger at this position.
9. Install and adjust Tip to suit. Using a 17mm wrench tighten lock bolt located on Tip. Congratulations! You are ready to begin enjoying the improved performance and driving experience of your MBRP Inc. performance exhaust system. We hope you enjoy your purchase.
