User guide

PAGE 1
PAGE 2
004-2008 FORD F150 Removal of Stock System: 1. Apply a penetrating lubricant liberally to all exhaust fasteners, hangers and rubber insulators. Figure 1 2. Loosen the clamp located behind the “Y” pipe. Refer to Figure 1. 3. Loosen the clamp located in front of the muffler. Refer to Figure 2. 4. Remove the hangers from the rubber insulators and remove the exhaust from the vehicle. If a hoist or hydraulic lift is not being used the tail pipe may need to be cut to clear the rear axle. Refer to Figure 3.
PAGE 3
2. Slide the 3” Hanger Clamp (short hanger) over the Extension Pipe and place the hanger into the existing rubber insulator. Refer to Figure 5. Figure 5 3. Slide the Muffler onto the Extension Pipe and loosely install the 3” Hanger Clamp (long hanger) into the existing rubber insulator for support. Refer to Figure 6. 4. Loosely install the Turn Down connecting it to the Muffler outlet through the 3” Hanger Clamp. Refer to Figure 7. 5. Align the exhaust as required.