Owners manual

183519 © 04/17 PAGE 3 OF 4
Figure 5
Figure 6
Figure 7
Figure 8
5. With the rear end now held in place, slowly lift the front of the
Rock Rail Assembly while lining up the holes of the front
bracket with the three (3) Carriage Bolts (again, be careful not to
push the bolts back into the frame). Refer to Figure 7.
With the front bracket against the frame surface, and the
Carriage Bolts hanging through the bracket holes, secure the
assembly with a 10mm Washer and 10mm Hex Nut on each of
the three (3) bolts. Do not fully tighten the nuts at this point.
6. Set the Front Inner Bracket in place over the top of the frame
and in line with the bracket on the RHS Front Rail Assembly.
Attach the top end of the Front Inner Bracket using two (2)
M10 Hex Bolts and M10 Hex Nuts, with two (2) 10mm
Washers on each. Leave the M10 Hex Nuts as loose as possible
for now. Refer to Figure 8.
7. Bring the bottom end of the Front Inner Bracket into position
and secure it to the assembly bracket using two (2) M10 Hex
Bolts and M10 Hex Nuts, with two (2) 10mm Washers on each.
Refer to Figure 8.
8. Begin tightening the four M10 Hex Bolts and M10 Hex Nuts to
bring the brackets together and the Rock Rail Assembly into
place on the frame, but do not fully tighten them yet.
A socket extension can be used through the bottom hole of the
brackets with a swivel joint adapter to aid in tightening the
hardware at the top end of the bracket. Refer to Figure 9.
9. At the front bracket location of the RHS Rear Rail Assembly,
place one of the 12mm Bolt Spacers on the inside of the frame in
line with the frame and bracket hole, and then insert one of the
M12x30mm Carriage Bolts through to the outer surface of the
bracket.
Secure the Carriage Bolt with an M12 Hex Nut and 12mm
Washer, but do not fully tighten.
Refer to Figure 10 (Refer to Figure 11 for LHS).
10. Now, fully tighten the Black ½” Hex Bolt and Black ½” Hex
Nut securing the RHS Front Rail Assembly and RHS Rear Rail
Assembly together.
11. Fully tighten the four (4) M10 Hex Bolts and M10 Hex Nuts of
the Front Inner Bracket.
12. Fully tighten the three (3) M10 Hex Nuts on the front bracket of
the RHS Front Rail Assembly.