INSTALLATION OF THE OCF TACOMA ROCK RAILS Figure 1 x3 Figure 2 1. Insert the end tubes of the RHS Front Rail Assembly into the tubes of the RHS Rear Rail Assembly and join the two using a Black ½” Hex Bolt, two (2) Black ½” Washers and a Black ½” Hex Nut. Do not fully tighten the hardware yet. Refer to Figure 1. 2.
Figure 5 5. With the rear end now held in place, slowly lift the front of the Rock Rail Assembly while lining up the holes of the front bracket with the three (3) Carriage Bolts (again, be careful not to push the bolts back into the frame). Refer to Figure 7. With the front bracket against the frame surface, and the Carriage Bolts hanging through the bracket holes, secure the assembly with a 10mm Washer and 10mm Hex Nut on each of the three (3) bolts. Do not fully tighten the nuts at this point. 6.
13. Fully tighten the M12 Hex Nut on the front bracket of the RHS Rear Rail Assembly. 14. Fully tighten the M10 Hex Nut on the rear bracket of the RHS Rear Rail Assembly. Figure 9 15. Repeat Steps 1-14 for the LHS Rock Rail Assembly! Congratulations! You’re finished! We are sure that you will enjoy this Off Camber Fabrications product by MBRP Inc.