Owners manual

182854 10/15 PAGE 3 OF 4
Figure 5
5. The headliner has to be temporarily lowered or
removed to proceed with the next steps, refer to
manufacture instructions for removal. Refer to
Figures 11-18.
6. With the headliner out of the way use the Inside
Pillar Templates to mark the access holes inside
the vehicle on both the sides of the vehicle. Make
sure the airbag is not in the way. Temporarily
reposition it while marking and drilling. With the
templates secured with tape mark the hole
locations, two per side.
Refer to Figure 5.
7. After drilling a pilot hole enlarge it to ¾” using a
drill or hole- saw. Be sure to drill only through the
bottom layer of steel. Refer to Figure 6.
8. Position the Seal and Driver –Side Bracket and
use the hardware provided to install the Driver-
Side Bracket .Make sure you to not over tighten
the ¼” Rubber-Backed Washer. A small amount
of sealer on each hole is also recommended. Refer
to Figures 7 & 8.
9. Repeat step 8 for the Passenger -Side Bracket
but leave it slightly loose to be able to install the
light bar.
Figure 6
Figure 7
Figure 8