Operation Manual

17
beep alarm tone will be heard if the code is
correct.
3.
The CBT function ends if it exceeds 45 seconds.
It will then enter ICM recording in “ANSWER
& RECORD” mode, or ends on-line operation
in “ ANSWER ONLY” mode or in “SYSTEM
STANDBY” mode.
4. The corresponding touch tone commands are
as follows:
End CBT functions press ”#”.
The CBT code is initially preset to ”267”. You
can change the code to any 3 digits from 000 to
999. The procedure of CBT code setup / display
is as follows:
1. Press the [REPEAT ]
key for about 2 seconds
and release to display CBT code.
The code display / setup will be high digit
first, then middle digit, and then low digit.
2. Press the [FORWARD ] or the [REPEAT
]
key to increase or decrease the digit.
3. Press the [ANS] key to select the correct digit.
4. Repeat step 2 and 3 to change following digit
setup.
5. If a keypress exceeds 8 second, the setup /
display procedure will be aborted.
6. Press the [STOP ] key to quit the CBT code
setup / display.
OPERATION
CBT CODE
CHANGE
Delta 1010 GB n e u 24.10.2002 12:00 Uhr Seite 17